Knowledge Base

G-1000: Selecting Tones for Realtime Parts

Knowledge Base Id:: 22618777
Tags:: g-1000

Use the following steps to select Tones:

1) Press TONE (near the display) so it is lit.
2) Use the DRUMS / PART knob to select the desired Part.
3) Press the GROUP buttons under TONE / PERFORMANCE to select a Tone group.
4) Press a numbered button under TONE / PERFORMANCE to select a Tone bank.
5) Press a numbered button again under TONE / PERFORMANCE to select a Tone.
6) Press the VARIATION buttons under TONE / PERFORMANCE to select a Variation
Tone.
7) Repeat steps 2 - 6 to select Tones for additional parts.
8) Press F5[Exit] when complete.