Knowledge Base
GR-30: Transposing A Tone
- Knowledge Base Id:
- 22619107
- Tags:
- gr-30
semitones) or up (up to 24 semitones). Use the following procedure to transpose
the pitch of the 1st or 2nd Tone:
1) Use the EDIT TARGET dial to select TONE MIX.
2) Use the PARAMETER SELECT dial to select [B] for TRANS 1ST.
3) Press the EDIT/PLAY button.
4) Use the [-] or [+] buttons to transpose the pitch of the 1st Tone. For
example, a setting of [-12] transposes the Tone one octave below normal pitch,
while a setting of [+12] transposes the 1st Tone one octave above normal pitch.
5) To transpose the 2nd Tone, follow the above procedure while setting
PARAMETER SELECT on [C] for TRANS 2ND.
6) Use the PARAMETER SELECT dial to select 'WRITE TO' and use the [-] or [+]
buttons to select a Patch location. (Remember that this procedure will
overwrite the old Patch in this location).
7) Use the PARAMETER SELECT dial to select 'WRITE PATCH' and press the [-] and
[+] buttons simultaneously to WRITE the patch into memory.