Tips for eliminating the "blip" noise that might occur after VariPhrase encoding:

 
 

Even if you made a perfect loop on your sample using the Sample Edit function, there are cases when a "blip" noise can be heard after VariPhrase encoding. If this happens, try the following settings and then encode again:

In the Sample Edit screen, press the [LOOP FWD] tab and [LOOP BWD] tab, and set the Loop Start/End points as mentioned below.

- In [LOOP FWD] page, set the Loop Start Point two or three wave cycles behind the Sample Start Point, and the Loop End Point two or three wave cycles in front of the Sample End Point.

- In [LOOP BWD] page, set the Loop End Point two or three wave cycles behind the Sample Start Point, and the Loop Start Point two or three wave cycles in front of the Sample End Point.

CLOSE